This is a 1/4" W x 5" L (length of wire to top of bunny). This orifice hook is made completely by hand, by me. The bunny is made from polymer clay, hand sculped, baked for hardness & durability, with a glaze applied. The hook is twisted 20 gauge wire, and is rounded for no snagging of fine fibers. This orifice hook should work with most commercial spinning wheels.
Each hook has an eye wire in the top for putting a ribbon or yarn in for hanging. Please let me know if you have certain requirements for your hook, like a longer wire hook for example. I can make these adjustments for you.
Please measure & re-measure your orifice opening to make sure this will fit your wheel. The hook end is 1/4", so you will need at least 5/16" for your opening. You can however rebend the wire if needed.
Each hook has an eye wire in the top for putting a ribbon or yarn in for hanging. Please let me know if you have certain requirements for your hook, like a longer wire hook for example. I can make these adjustments for you.
Please measure & re-measure your orifice opening to make sure this will fit your wheel. The hook end is 1/4", so you will need at least 5/16" for your opening. You can however rebend the wire if needed.
